Handset Receiver Volume Control
(located on the left side of the handset)
1To increase the sound level, press the akey.
2To decrease the sound level, press the @I key.
If you subscribe to special local telephone company services like Call Waiting or Call Forwarding, you can access them by pressing I=[ whenever you would press the switchhook on a regular phone.
To redial the last number dialed from the handset:
1Press [PHaNEl.
2' Wait for the PHONE indicator to go on and for a dial tone.
3Press m.
The last number you called is stored in the redial memory until you dial
i another number.
9.- NU0
Mute allows you to hew your caller but prevents the caller from hearing
you.
1 Press m.
2 The MUTELOW BATT indicator will light to indicate the Mute feature is activated.
3 To continue your conversation, press lMUrEl again.
Press b@@ on the handset during incoming ringing to disable the ringer for the duration of the call.
The Hold feature allows you to keep a call on the line while you step away from the phone or while you or someone else takes the call on an extension phone.
continued
1 Press lHOLD].
2The PHONE indicator will blink slowly to indicate the call is on hold.
3To release Hold, press @@ again.
IMPORTANT.- If you are using the Hold feature to switch to another extension, you must first place the call on Hold. After the extension phone has been picked up, release the Hold feature and press [OFF] on the 9111 to resume your conversation on the extension phone.
AthranadHoSelea-
The Cordless Telephone 9 111's advanced Autoselect feature will automatically select the clearest channel, even during a conversation. During automatic channel change your conversation may be interrupted for about 1 second while the unit scans and selects a new channel.
If you have dial pulse (rotary) service, this feature allows you to enter codes or tones needed to operate answering machines, or use electronic banking services, calling cards, and other special services. This feature will operate most special services; however, some services may actually require a touch tone line. To be sure, ask the company that provides the special service.
NOTE: If you have touch tone service, you do not need to use the Temporary Tone feature.
To use temporary tone dialing:
Dial the call n&rnally. Press I+TONE].
Enter numbers or symbols required.
End the call normally (Temporary Tone is automatically shut off).
The handset ringer is capable of four different types of ringing tones. The following sections detail how to change the different tones and to turn off the ringer on the handset.
To program, the handset must be
[OFFI.
To select a different ringer type do
the following:
1 Press m.
2 Press O.
3 Press a key
ringer type.
4 Press m.
To turn off the ringer on the handset,
do the following: 1 Press m.
2 Press @l.
3 Press
To turn ringer on again, see "Programming the Ringer Type."
To check the ringer which is currently programmed, do the following:
1Press (PROG].
2Press O .
3Press Q again to check the ringer.
4Press m).
This feature is useful if you misplace the handset.
To locate the handset using the Handset Locator feature:
1Press (PAGEIHANOSETLOCATOR].
2A repeating paging tone is
sounded at the handset for approximately 30 seconds.
To cancel the Handset Locator feature:
Press [OFFI on the handset or press
[ P A G ~ A N D S ELOCATOR] on the base.