IbiMngthe Padc

~l f i a ~ B a t t ~ as rings, bracelets, and keys. The

	You will know the batteries need	battery or conductor may overheat
		and cause harm.
	charging when:
		Charge the battery provided with
	The phone beeps two times when
		or identified for use with this
	you press lPHorVEl to answer or
		product only in accordance with
	make a call.
		the instructions and limitations
	The MUTELOW BATT indicator
		specified in this manual.
	on the handset flashes.
		Observe proper polarity orientation
	The phone does not respond when
		between the battery and battery
	you press @@@and the PHONE
		charger.
	indicator does not go on.

switch into the Power Reserve mode. When operating in the Power Reserve mode., the phone's features and functions should operate normal- ly until the spare battery charge has been depleted. When power is restored to the telephone base unit, the phone will automatically switch back to its normal operating mode.

ZMPORTANE The amount of time the Cordless Telephone 91 11 will operate during a power failure will

Place the handset in the base so the IN USEKHARGE indicator goes on. The batteries will be fully charged in 6 hours. Once the batteries are fully charged, you need only put the handset in the base when the MUTELOW BATT indicator flashes.

If it is more convenient for you to do so, you can leave the handset in the base all the time. It is impossible to overcharge the batteries.

If the batteries don't charge properly:

If you get a low-battery signal even after 6 hours of charging, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to

persons or damage to the telephone, read and follow these instructions carefully.

Use only Replacement Battery

3470.

Do not dispose of the battery

in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Exercise care in handling batteries in order not to short the battery with conducting materials such

1Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward.

2Lift out the old battery pack.

3Place the new battery pack in the compartment. Make sure the metal contacts on the underside of the battery are aligned with the charging contacts in the battery compartment.

4Replace the cover by sliding it on its track up over the battery compartment until it snaps firmly in place.

5The new batteries must be charged before using your telephone. Place the handset in the base unit and allow it to charge for 6 hours. The telephone may operate before that but, for best performance, let the batteries charge fully.

power^

The Cordless Telephone 9111 has the ability to provide back-up power to the telephone base in the event of a power failure. For this feature to work, it is necessary to have a fully charged spare battery (PURCHASED SEPARATELY) installed in the base unit Spare Battery Charger (located under the directory card on the tele- phone base unit). If a power failure or interruption occurs, the Cordless Telephone 9111 will automatically

vary depending on use and spare battery charge level.

The Cordless Telephone 9 111 is equipped with a spare battery charger built into the base unit. The spare battery charger allows you to always have a charged battery available, should your handset battery discharge during normal use.

To install the Spare Battery Pack

(PURCHASED SEPARATELY):

1Open the base unit battery compartment.

2Place the spare battery pack in the battery compartment. Make sure the metal contacts on the underside of the battery are aligned with charging contacts in the battery compartment.

3Replace the battery compartment cover.

4When the battery is installed properly, the SPARE BATTERY indicator on the base unit will be illuminated.

5The spare battery will be fully charged after 16 hours. Please note that the SPARE BATTERY indicator will always be illurninat- ed when a spare battery is installed.