Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below. If you subscribe to
The telephone base comes ready for tabletop use. If you want to mount your telephone on a wall, refer to Wall mount installation on pages
Electrical outlet not controlled by a wall switch
Plug the large end of the base power adapter into an electrical outlet not controlled by a wall switch.
Plug the small end of the base power adapter into the power jack on the bottom of the telephone base.
Plug the large end
of the charger’s power adapter into an electrical outlet not controlled by a
wall switch.
Telephone wall jack
Plug one end of the telephone line cord into a telephone wall jack.
A DSL filter (not included)
is required if you have DSL
Telephone line cord
Route the cords through the slots.
Plug the other end of the telephone line cord
into the tel. line jack on the bottom of the telephone base.
Ensure the small end of the charger’s power adapter is plugged into the power jack on
the bottom of the charger.
important information:
Use only the power adapters provided with this product. To obtain a replacement, visit our website
at www.telephones.att.com or call 1 (866)