AT&T 6100 user manual Installation, Before You Install, Install the handset battery

Page 4

6100_book_1ATT 11/25/00 12:37 PM Page 3

INSTALLATION

Before You Install

1Choose a location for the base near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

a)Remove battery compartment cover by pressing on the indentation

and sliding downward.

b)Align two holes in plug with socket pins, and snap the plug into place.

c)Place battery pack in compartment with the wires in the lower left

corner, along the bottom of the battery pack.

d) Replace cover by sliding it up into place.

3 Attach the belt clip to the cordless handset (optional).

To attach	To remove
	3

Image 4

Contents MHz Cordless Telephone Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Installation Before You InstallInstall the handset battery Attach the belt clip to the cordless handset optionalTable/Desk Installation Check for dial tone Connect the telephone line cord Connect the power cord Wall InstallationPosition the wall mount adapter on the base Follow Steps 4-5 in Table/Desk Installation Mount the base on the wallHandset Volume Access Internet Calling RedialTelephone Operation Make or AnswerHandset Locator Making Internet Calls Ringer Off/Battery SaveHandset Ringer Style Headset Jack Operating RangeTelephone Memory Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack Case of Difficulty If the phone does not ring when you receive a callIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If you hear noise or interference when using the phoneIf you lose a call after changing channels