AT&T 6100 user manual Replacing the Handset Battery Pack

Page 15

6100_book_1ATT 11/25/00 12:37 PM Page 14

BATTERIES

Replacing the Handset Battery Pack

1Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward.

2Lift out the old battery pack and disconnect.

3Align the two holes in the new battery pack’s plug with the socket pins, and snap the plug into place. Place the battery pack in the compartment with the wires in the lower left corner, along the bottom of the battery pack.

4Replace the cover by sliding it up into place.

5The new battery pack must be charged before using the phone. Place the handset in the base and allow it to charge for at least

24 hours the first charge. The telephone might operate before that, but for best performance, let the battery pack charge fully.

14

Image 15

Contents Part 1 Important Product Information MHz Cordless TelephoneAdvanced American Telephones. All rights reserved Contents Attach the belt clip to the cordless handset optional InstallationBefore You Install Install the handset batteryTable/Desk Installation Check for dial tone Wall Installation Connect the telephone line cord Connect the power cordPosition the wall mount adapter on the base Mount the base on the wall Follow Steps 4-5 in Table/Desk InstallationMake or Answer Handset VolumeAccess Internet Calling Redial Telephone OperationHandset Locator Ringer Off/Battery Save Making Internet CallsHandset Ringer Style Operating Range Headset JackTelephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels