AT&T 7625 user manual Answering System Operation

Page 19

AT&T 7625 WC_1ATT 7/28/98 11:30 PM Page 1

2

Cordless Digital Answering System

Telephone 7625

Answering System Operation

From a Remote Touch Tone Phone

1Dial your telephone number.

NOTE: Remember that if the system was set to TOLL SAVER, it will answer after two rings if there are new messages and after four rings if there are no new messages.

2When the system answers, enter your

3-digit remote access code. The system announces the number of messages you have, then beeps twice and is ready to accept a command.

3Enter a command (see other side)

Your Remote Access Code _____________.

(The preset code is 500.)

©1998 Philips Consumer Communications L.P.

All rights reserved. Printed in Mexico.

848232930 Issue 1AT&T

2

Cordless Digital Answering System

Telephone 7625

Answering System Operation

From a Remote Touch Tone Phone

1Dial your telephone number.

NOTE: Remember that if the system was set to TOLL SAVER, it will answer after two rings if there are new messages and after four rings if there are no new messages.

2When the system answers, enter your

3-digit remote access code. The system announces the number of messages you have, then beeps twice and is ready to accept a command.

3Enter a command (see other side)

Your Remote Access Code _____________.

(The preset code is 500.)

©1998 Philips Consumer Communications L.P.

All rights reserved. Printed in Mexico.

848232930 Issue 1AT&T

Image 19

Contents Part Table of Contents Case of Difficulty InstallationAudible Signals Batteries Answering System Operation At the BaseInstallation To wall mount the phone Install the handset batterySet the handset ringer switch Connect the telephone line and power cordsAnswering a Call Ending a Call Using the HandsetHandset Volume Making a CallHandset Locator MuteTemporary Tone Recording a Telephone ConversationStoring Memory Numbers Operating RangeMemory Changing ChannelsAnswering System SET-UP Ring Select, Toll Saver and the Remote Access Code Setting the ClockAnnouncement Play/Silent Memory Capacity Reviewing the Setting in the Feature Set-Up MenuVolume Control Incoming Message LengthRecording a Memo Power FailuresSaving Messages Deleting MessagesVoice Help Menu Accessing the Answering System From the Cordless HandsetAccessing the Answering System from a Touch Tone Phone Using the Voice Help MenuYou will hear Select the second digit then press Remote Access CommandsClock Outgoing AnnouncementYou will hear Select the third digit then press Audible Signals Case of Difficulty Charging the Handset Battery PackReplacing the Battery Pack BatteriesIf you hear noise in the handset and the buttons don’t work If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you hear other calls while using the phoneAnswering System Operation AT&T 7625 WC1ATT 28/98 1130 PM