Operating Range, Memory, Changing Channels

OPERATING RANGE

This cordless integrated telephone answering system operates at the maximum power allowed by the Federal Communications Commission (FCC). Even so, the handset and base can communicate over only a certain distance—which can vary with the locations of the base and handset, the weather, and the con- struction of your home or office.

*NOTE: For best performance, point the base antenna upwards, as shown in “INSTALLATION.”

If the handset is moved to a point where the base and handset can no longer communicate, you are “out of range.” When you try to make a call, the handset will sound two short beeps to indicate that you are out of range.

If you receive a call while you are out of range, the handset might not ring—

or, if it does ring, the call might not connect when you press . Move

closer to the base, then press to answer the call.

If you move out of range during a phone conversation, you will hear noise or interference. To improve reception, move closer to the base.

If you move out of range without pressing , the phone will be left “off the hook.” To hang up, walk back into range, periodically pressing

until the PHONE light goes off.

Changing Channels

This cordless telephone has an advanced 25-channel AutoSelect feature that minimizes the chance of interference. Every time you answer or make a call, the AutoSelect feature searches for and selects a clear channel.

In the unlikely event that you hear noise or interference while using handset:

1Press .

2If the interference does not clear, continue to press until you find a clear channel (your call will not be interrupted).

—OR—

Move closer to the base and press .

*NOTE: You must be in range to change channels.

MEMORY

This cordless answering system can store 10 different phone numbers that you

can dial just by pressing and one of the number buttons.

Storing Memory Numbers

1Make sure the handset is OFF.

2Press .

3Enter the phone number (up to 16 digits).

4Press .

5Press any number button (0-9) for the memory location where the number is to be stored.

6You will hear a three-part tone that confirms the number was stored

properly. If you hear a long buzzing tone, or nothing at all, press , then follow the steps above to store the number again.

For example, to store 555-1234 in memory location 9: press ,

then press , , .

*NOTE: You may choose to store emergency numbers in memory locations. The manufacturer assumes no responsibility for customer

reliance upon this feature.

Storing a Pause in a Memory Number

If this phone is connected to a switchboard, you might have to dial an access number (usually 9) to get an outside line. You can store the access number and a pause in the dialing sequence; the pause allows the switchboard enough time to get an outside line dial tone.

To insert a pause in a stored number:

When storing a number in memory, press and hold down the number button that comes before the pause until you hear the second beep. This inserts a 1.5 second pause after that digit. If you hold the number button down longer, you will hear more beeps as additional pauses are stored.

*NOTE: Each pause you store is counted as a digit. You can store up to 16 digits in each memory location.

For example, to store 9, PAUSE, 555-1234 in memory location 3: Press

, then hold down until a second beep is heard. Then press

, , .