AT&T 7625 user manual Mute, Temporary Tone, Recording a Telephone Conversation, Handset Locator

Page 7

TELEPHONE OPERATION (From the Handset)

Mute

The Mute feature allows you to hear your caller, but prevents the caller from hearing you.

To activate the Mute feature:

•Press .

•The MUTE/LOW BATT light will go on and the caller will not be able to hear you.

To let the caller hear you again:

•Press .

•The MUTE/LOW BATT light will go off and the caller can hear you again.

Temporary Tone

*NOTE: If you have touch tone service, you do not need to use the Temporary Tone feature.

If you have dial pulse (rotary) service, this feature allows you to enter codes or tones needed to operate certain answering machines or to use electronic bank- ing services, calling cards, and other special services. This feature will operate most special services; however, some services may actually require a touch tone line. To be sure, ask the company that provides the special service.

1Dial the call, then press . Any dial buttons pressed after this send tone signals.

2After you hang up, the phone automatically returns to dial pulse (rotary) dialing.

Recording a Telephone Conversation

Once you have established a connection with the answering system, you can record a telephone conversation. The telephone conversation will be recorded along with other messages.

1While you are having a conversation on the cordless handset, press

and wait for the ANS SYS light to go on to show that you have made a connection with the answering system. Press .

2The system will beep once and start recording from the telephone line. The recording will be treated as a new message.

3To stop recording, press .

TELEPHONE OPERATION (From the Base)

Page

The Page feature allows you to signal someone at the handset from the base.

•Make sure the Handset In Use light is not lit on the base.

•Press on the base. A three-part paging tone will sound at the handset.

*NOTE: The handset Ringer Switch must be set to ON to operate the PAGE feature.

Handset Locator

This feature is useful if you misplace the handset.

To locate the handset using this feature:

•Press and hold on the base for approximately four seconds. A repeating paging tone is sounded in the handset.

To cancel the handset locator feature:

•Press on the handset or on the base.

*NOTE: The Handset Locator feature will turn itself off in approximately three minutes if you haven’t turned it off before then.

10

11

Image 7

Contents Part Table of Contents Case of Difficulty InstallationAudible Signals Batteries Answering System Operation At the BaseInstallation To wall mount the phone Install the handset batterySet the handset ringer switch Connect the telephone line and power cordsAnswering a Call Ending a Call Using the HandsetHandset Volume Making a CallHandset Locator MuteTemporary Tone Recording a Telephone ConversationStoring Memory Numbers Operating RangeMemory Changing ChannelsAnswering System SET-UP Ring Select, Toll Saver and the Remote Access Code Setting the ClockAnnouncement Play/Silent Memory Capacity Reviewing the Setting in the Feature Set-Up MenuVolume Control Incoming Message LengthRecording a Memo Power FailuresSaving Messages Deleting MessagesVoice Help Menu Accessing the Answering System From the Cordless HandsetAccessing the Answering System from a Touch Tone Phone Using the Voice Help MenuYou will hear Select the second digit then press Remote Access CommandsClock Outgoing AnnouncementYou will hear Select the third digit then press Audible Signals Case of Difficulty Charging the Handset Battery PackReplacing the Battery Pack BatteriesIf you hear noise in the handset and the buttons don’t work If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you hear other calls while using the phoneAnswering System Operation AT&T 7625 WC1ATT 28/98 1130 PM