Paradyne 4000E Securing the Connecting Cables, Configuration and Management

Securing the Connecting Cables

Position all connecting cables such that they will not become a tripping hazard or pull loose from the chassis; secure with cable ties or hook-and-loop fastener straps.

Configuration and Management

Although no configuration is necessary to run subscriber lines at the default settings, all 4000E parameter settings are software selectable via Command Line Interface (CLI), Simple Network Management Protocol (SNMP), and/or the Network Management System (NMS). 4000E management capabilities depend upon the management module model installed in your chassis. Once the management module has been initialized, the interface modules installed in your 4000E may also be configured as desired. Refer to the following for further information:

Document	Contents
Management module	￿module installation
installation instructions	port pinouts
(model-specific)	parameter defaults
	parameter configuration options
	management system capabilities
Uplink module installation	￿module installation
instructions	port pinouts
(model-specific)	parameter defaults
	parameter configuration options
Interface module user	￿module installation
guides	distance and bandwidth capabilities
(model-specific)	port pinouts
	parameter defaults
	parameter configuration options
CLI Management User	￿management module initialization instructions
Guide	command user guide
	command definitions
	configuration options common to all management
	module models
	configuration options common to all interface module
	models
NMS Management User	￿management module initialization instructions
Guide	screen by screen user guide
	parameter definitions
	configuration options common to all management
	module models
	configuration options common to all interface module
	models

IPD4-A2-GZ40-00 February 2005 15