Paradyne 4000E installation instructions Introduction, Unpacking and Inspecting the Equipment

Page 3

9.Upon such termination, the Licensee shall refrain from any further use of the Software and destroy the original and all copies of the Software in the possession of Licensee together with all documentation and related materials.

10.This Agreement shall be governed by the laws of the State of Florida, without regard to its provisions concerning conflicts of laws.

Introduction

Paradyne’s 4000E IP Broadband Loop Carrier (BLC) provides a high capacity and native IP Ethernet foundation for a variety of feature-rich multi-service access mulitplexer modules.

The 4000E BLC features a high capacity backplane delivering up to 8 Gbps throughput, and providing a non-blocking architecture for even the highest bandwidth broadband access technologies, such as ADSL2+. It supports a single uplink, management, and switching module connected to the dual backplanes with redundant modular backhaul/uplink ports to support 10/100 Ethernet, GigE (copper or fiber), T1/E1, and dual bonded T1/E1 uplink modules.

The 4000E BLC is environmentally hardened for installation in Remote Terminals or street cabinets. For flexibility of installation the 4000E BLC has removable mounting brackets that can be placed in increments of 1.45” up to 9.28” from the front of the chassis, allowing for multiple installation options in either 19" or 23" equipment racks.

Unpacking and Inspecting the Equipment

HANDLING PRECAUTIONS FOR

!STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact your nearest sales or service representative.

The following components should be included in the shipping container:

￿1 – 4000E BLC with 1 fan module and 12 blank plates

￿4 – Rubber Bumper Screws

IPD4-A2-GZ40-00

February 2005

3

Image 3
Contents Software and Firmware License Agreement ContentsFebruary IPD4-A2-GZ40-00 Unpacking and Inspecting the Equipment IntroductionInstallation on a Tabletop Installation OptionsQVWDOODWLRQLQD5DFN Installing a Management Module Installing Your Management ModuleInstalling Your Interface Modules $%&$ Powering Up Your 4000E BLC Positive Negative Power Lead Subscriber Lines Uplink Connections#21# February IPD4-A2-GZ40-00 Configuration and Management Securing the Connecting Cables# # Product Documentation Online SpecificationsImportant Safety Instructions United States EMI Notice Warranty, Sales, Service, and Training Information
Related manuals
Manual 20 pages 19.04 Kb