Samsung GH68-15049A quick start WEP500, Before using your headset, Check the accessories

Page 1

Quick Start Guide

Bluetooth Mono Headset

WEP500

Get connected in 4 quick steps

Charge your headset

Put your headset in pairing mode Turn on Bluetooth on your phone and pair with headset

Test and use

Start here

Before using your headset

Thank you for purchasing the Samsung Bluetooth Mono Headset WEP500. We hope you will be delighted with its operation.

Take a moment before you get started to familiarize yourself with your new headset.

Secondary

Multi-Function

button

microphone

 

Earpiece

 

Volume Up

 

button

 

Volume Down

Indicator light

button

Charging contact

 

Primary

 

microphone

 

Check the accessories

Make sure you have the following items with your headset:

Headset cradle, Adapter, User’s Guide,

3 Earpiece Covers (Large, Medium, Small)

NOTE:

Your headset supports the Headset and/or Hands-Free Profile(s).

Charge your headset

Charge the headset's battery fully before using the headset for the first time.

1Put the headset in the supplied headset cradle and close the cover.

2Plug the adapter into the headset cradle’s socket.

3Plug the adapter into the electrical outlet.

Charge the headset until the red light on the headset turns to blue.

The headset will be fully charged in approximately 2 hours.

4Remove the adapter from the headset cradle.

NOTE:

The headset is not able to operate while charging. Try to reconnect after charging is completed.

Headquarters:

1301 East Lookout Drive Suite 150

Richardson, TX 75082

Internet Address: http://www.samsungmobileusa.com/ accessories

Customer Care Center:

1-888-987-4357

Guide No.: GH68-15049A

07/2007. Rev. 1.1

Put your headset in pairing mode

Before you can use your headset, you must pair it with your phone.

If you turn on the headset for the first time, it proceeds into pairing mode immediately.

If you have paired the headset with other Bluetooth devices, make sure that the headset is off (see Turn headset on/off on the reverse side of this guide).

Then press and hold the Multi-Function button until the indicator light turns solid blue after blinking.

Turn on Bluetooth on your phone and pair with headset

1Set your Bluetooth phone to discover the headset by following your phone's user guide.

Typically, the steps involve going to the Settings, Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices.

Your phone will find the Samsung WEP500 headset.

2Select Samsung WEP500.

3When the phone asks if you want to pair with it, confirm by selecting Yes or OK.

4Enter the headset passkey or PIN, 0000.

Test and use

Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call:

1Place the headset over your ear.

See Wear the headset on the reverse side of this guide.

2On your phone, make a call to the number you want.

3If your phone and headset are successfully paired, you will hear ringing on the headset.

After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset.

Using your WEP500

See Features and Functions Guide on the reverse side of this guide

for information on using your WEP500.

Image 1
Contents Check the accessories Before using your headsetPut your headset in pairing mode WEP500Use enhanced features Adjust the volumeMeaning of the indicator light Turn headset on or off