GETTING STARTED
Sending a Call
1.Select the desired radio channel.
2.Press the PTT button and speak clearly into the microphone.Your mouth should be
2.5to 5 cm away from the microphone.
3.When transmitting, the red indicator will light continuously.
4.Release the PTT button to listen.
Your radio may be configured for ‘Transmit Inhibit’ under certain conditions (e.g. when the channel is in use by others) in which case, the channel busy tone will sound when you press the PTT or call button to indicate that transmission is inhibited.
When the channel is free, the Channel Free
beep will sound, and you can make a call.
If your radio is equipped with a transmit time out timer (TOT), a warning tone
will sound a few seconds
before the transmission is cut off. Your radio may be programmed to inhibit retransmission within a preset time.
Receiving a Call
1.Turn your radio on and adjust the volume level.
2.Switch to the desired radio channel.
3.If, at any time, a call is received you will hear the call at the volume level you have set.
Note: The system may have a limited call time and the call may be terminated automatically if this call time is exceeded.
Cancelling a Call
At any time while setting up a call it may be cancelled by pressing the Monitor/Call Cancel button, or replacing the microphone in its holder (referred to as going “on hook”) .
The call timer can also cancel a call.
Ending a Call
A call should always be ended by pressing the Monitor/Call Cancel button, or replacing the microphone in its holder.
English 10