Whistler BT2200, BT3200, BT2300, BT3300 Check Battery Status, Battery Charge / Usage Time

Page 7

Storing and Recharging Headset

Recharging Headset - (continued)

2). Connect the headset to the charger as described. Please make sure that the charger plug is inserted correctly into the headset.

3). The red LED is illuminated during the charging process. When the headset is fully charged, the red LED turns off. Disconnect the charger unit from the headset after the charging process.

4). If the battery status is low, you will hear a warning signal in the headset.

Check Battery Status

Press both volume keys (+&-) for 10 seconds from power off status and then release. The red LED will indicate the battery status.

Low Battery: The red LED will flash approximately 4 times (fast)

Medium Battery: The red LED will flash approximately 2 times (slower)

Full Battery: The red LED will flash one time (long flash).

10

Storing and Recharging Headset

Battery Charge / Usage Time

	Model	Charge		Usage Time
		Charge
		Time	Stand-by	Speaking/music/intercom
		Time


	BT2200/2300	~ 3h	~180h	~14h

	BT3200/3300		~90h	~7h
	BT3200/3300		~90h	~7h

The usage times may vary depending on the number of connected systems. The battery must be replaced by Whistler personnel.

11

Image 7

Contents Whistler Bluetooth Headsets Table of Contents Introduction Customer ServiceSafety Instructions What is Bluetooth?Main Unit Speakers Microphone Accessories Features ComponentsStoring and Recharging Headset Match Unit to Helmet TypeBattery Charge / Usage Time Check Battery StatusInstallation of Speakers and Microphone Installing HeadsetSelect mounting method based on helmet type Key Function Button Callouts Button FunctionsBasic Functions and Operation Pairing to a Cell PhoneAutomatic and manual call acceptance Play music from mobile phone Connecting the headset with cell phoneConnection headset with audio device Pairing to an Audio DeviceDisconnect cell phone and Bluetooth headset Receiving a call while listening to musicVox Function Operating and disconnecting the audio deviceIntercom Function Headset DistancePairing of headsets on channel Adjustment of microphone sensitivityMusic and Intercom Cell phone and intercomDisconnect headset from music / cell phone Intercom Function General InformationStatic Noise Problem Bluetooth Headset cannot be switched on SpecificationsTroubleshooting Technical Data BT2200/2300 BT3200/3300FCC Information Problem The voice over the microphone is too lowService Under Warranty Warranty InformationConsumer Warranty Service Out of WarrantyPlease allow 3 weeks turn around time Customer Service