Intercom Function
Vox Function (continued)
4). When activating the VOX after is has turned off, a delay of 3 seconds is required before resuming conversation. The activation of the VOX will provide a sound in the headset.
5). Depending on the helmet type and motorcycle, ambient noises could activate the VOX at higher speeds (~60 MPH). In that case, please protect the microphone as much as possible from ambient noises and lower the microphone sensitivity. If you ride for long hours at high speeds, we recommend that you switch off channel 2 at one headset. If the channel is switched on again, the headsets are paired and the communications can resume.
Adjustment of microphone sensitivity
If the VOX does not function appropriately, the microphone sensitivity should be adjusted. The individual adjustment depends on the helmet, riding conditions, and the voice level.
1). Press [+] &
2) Adjustments
Low: 4x flashing within 2 seconds
Middle: 2x flashing within 2 seconds
High: 1 long flash for 2 seconds
Repeat key presses until adjustment level desired.
24
Intercom Function
Pairing of headsets on channel 2
Before you start to pair the headsets on channel 2, please switch off channel 1 as well as all other Bluetooth devices in your environment.
1). Headset 1: Press the [+] key for 7 seconds (from a power off status) until the green LED starts flashing rapidly. This headset will be the SLAVE.
Headset 2: Press the [M] key and the [+] simultaneously for 7 seconds until the green LED starts flashing rapidly. This headset will be the MASTER.
2). As soon as the headsets have paired, the green LEDs will flash slower.
3). As long as the headsets have not been reset, they will connect automatically with each other every time you turn them off then on again.
25