Cardo Q2 manual SET UP for Mobile Phone Calls Pairing, SET UP for Bluetooth GPS Device Pairing

1.Place the scala rider Q2 into Intercom Pairing mode following the instructions in the PRIMARY BUDDY PAIRING section above.

2.Once the Red Light begins flashing rapidly, press and hold Volume up for three seconds.

3.The Red and Blue Lights will flash five times, confirming that the Reset Pairing was successful.

STEP 3

SET UP FOR MOBILE PHONE CALLS: PAIRING

If you have a Bluetooth enabled mobile phone and would like to make and receive phone calls using the scala rider Q2, you must first pair your headset to the mobile phone.

NOTE: If you have a compatible Bluetooth GPS device you wish to use with the scala rider Q2, please skip this step, and continue ahead to STEP 4: SET UP FOR BLUETOOTH GPS DEVICE.

Pairing is a one time process. Once the headset is paired to a specific mobile phone during this Setup Procedure, they will remain paired and automatically recognize each other whenever they are within range. If the connection between the phone and headset is lost, tap the CTRL button to reconnect the devices.

TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH MOBILE PHONE

1.Turn on your phone and make sure its Bluetooth function is activated.

2.With the scala rider Q2 headset turned ON, press and hold the CTRL Button for at least six seconds until the Red and Blue Lights begin rapidly alternating.

3.Search for Bluetooth devices on your phone by following the

phone’s instructions. Please consult your phone’s User Manual for more information.

4.After a few seconds the phone will list the scala-rider Q2 as a discovered device. Select it and follow your phone’s instructions to accept the pairing.

5.When prompted enter 0000 (four zeros) as your PIN or passkey.

6.Your phone will confirm that pairing has succeeded and the headset will begin flashing slowly in Blue.

NOTE: If the Pairing process is not completed within two minutes the headset will return to Standby mode.

With some mobile phones, you may need to tap the CTRL button to connect the headset to the phone after pairing is complete. The scala rider Q2 headset will automatically connect to the last phone connected to the headset.

STEP 4

SET UP FOR BLUETOOTH GPS DEVICE: PAIRING

If you have a Bluetooth enabled GPS device and would like to transmit navigation instructions and sounds from the GPS device through the headset’s speakers, you must first pair your headset to the GPS device.

NOTE: Not all Bluetooth enabled GPS devices allow connections to Bluetooth headsets like the scala rider Q2. Please consult your GPS device’s User Manual for more information.

TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH GPS DEVICE:

1.Turn on your GPS device.

2.With the scala rider Q2 headset turned ON, press and hold the CTRL Button for at least six seconds until the Red and Blue Lights begin rapidly alternating.

6 scala rider® Q2™ MultiSet