Answering a Call

TELETALKER™ Model TEL 040Installation Guide & User Manual

Step 1: Check the Volume Control setting, lift the handset.

Step 2: Press the Amplify button. The red Amplify indicator should light.

Step 3: Adjust the Volume and Tone controls to comfortable set- tings.

Step 4: When you hang-up the phone, the Amplify function automatically turns off.

Using the TELETALKER With A Hearing Aid

The handset can be used directly with hearing aids equipped with a telecoil (T-coil ). Move your hearing aid T-switch to the “T” posi- tion and hold the handset close to your hearing aid. The volume can be adjusted with the TELETALKER volume control.

Using the TELETALKER With Auxiliary Assistive Listening Devices Through its 3.5mm Neckloop/Aux Jack, the TELETALKER can be used with a variety of assistive listening devices (ALDs) such as neckloops, headphones, and cochlear processors. Note:

An attenuator cord (WCA 040) must be used with cochlear processors. Neckloops may be plugged directly into the jack.

fig. 8: Connecting An ALD

Step 1: Plug the device into the Neckloop/Aux jack (see fig. 8).

Step 2: Set the volume control to about half of full.

Step 3: Turn on the ALD and adjust the volume for comfortable listening.

Step 4: If the sound is weak, increase the volume on the

TELETALKER, then on your ALD.