Williams Sound TEL 040 user manual Case Of Difficulty

Installation Guide & User Manual TELETALKER™ Model TEL 040

In Case Of Difficulty

Cannot hear the other person speak. This only occurs when the TELETALKER is in Amplify mode.

When you use the Amplify feature, the TELETALKER operates in half-duplex mode. This means that while you speak, the hand- set receiver shuts off. If it did not, the extremely loud volumes produced by the TELETALKER would cause feedback.

When using the TELETALKER in Amplify mode, do not speak when the other party is speaking.

Can answer calls but cannot make them

The pulse/tone switch is set in the wrong position. Change it to pulse mode.

No dial tone when you pick-up handset

There are a number of potential causes to this problem:

1.Cords on handset or phone are not plugged into jacks. Make sure connectors are plugged in securely.

2.The cord could be damaged. If so, replace the cord.

3.The wall jack could be improperly wired. Check the wall jack for proper wiring.

4.Your phone line could be out of order. Contact your local phone company.

Can make calls, but phone doesn’t ring for incoming calls.

There are a number of potential causes to this problem:

1.The handset may not be placed properly on the base. Make sure it is resting properly on the base.

12