TELETALKER™ Model TEL 040 | Installation Guide & User Manual |
Step 5: Plug the Power Pack cord into the Power Jack located at the top end of the telephone. Plug the Power Pack into an unswitched AC outlet within 6 feet of the telephone. (see fig. 5)
fig. 5: Power Connection |
Step 6: Perform either Table/Desk installation or Wall installa- tion as outlined on the following pages.
For Table/Desk Installations
Step 1: Plug the long line cord into the jack on the back of the telephone base. (see fig. 6)
Step 2: Plug the other end of the line cord into a modular base- board jack. Make sure both ends snap into place firmly. (see fig. 6)
fig. 6: Line Cord Connection
Step 3: Lift the handset and check for dial tone. If you don’t hear a dial tone, see In Case Of Difficulty, page 12.
Note: To disconnect, squeeze the clip on the plug and pull it out from the jack. Remove the Power Pack plug from telephone.
7