OPERATION
Skip to next message — Press and release
ISKIP/SCANi.
Skip part of a message — Hold down {SKIP/SCAN': for a few seconds, then release it to resume playing. The system beeps while the button is held down.
Stop message playback — Press and
release \STOP:.
Saving Messages
The system saves your messages automatically i f you do not delete them. The system can save about 12 minutes of messages, including your announcement, for up to a total of 99 messages. When memory is full, you must delete some or all messages before new messages can be re- corded.
Oeletlng Messages
Delete all messages — Hold down 'DELETE\ The system announces "Messages deleted" and the Message Window displays 0. I f you haven't listened to all of the messages, the system beeps 5 times, and does not delete messages.
Delete selected messages — Press and re- lease IDELETE': while the message you want to delete is being played. The system beeps once, and continues with the next message. I f you want to check a message before you delete it, you can press REPEAT/SCAN] to replay a message before deleting it.
When the system reaches the end of the last message, the messages not deleted are renumbered, and the Message Window displays the total number of messages remaining in memory.
Recording a Memo
You can record a memo to be stored as an incoming message. The memo can be up to 3 minutes long, and w i l l be played back with other messages.
1 Press and release [MEMO]. After the beep, speak toward the microphone.
2 To stop recording, press [sToPi.
WIlBII MCmOIV IS FUll
The system can record approximately 12 minutes o f messages, i n c l u d i n g you r announcement, for up to a total o f 99 messages. Whe n memor y is f u l l , or 99 messages have been recorded, the Message Window flashes F. Delete messages to make room for new ones.
When memory is full, the system answers calls after 10 rings, and sounds 2 beeps instead of your announcement.
Remote Access Code
You can use many features of this answering system remotely from a touch tone phone. Most features can be accessed only after yjou,^^ enter a Remote Access Code, preset t d ' 5 0 0 ^ You can view the Remote Access Code by tapping {CODE].
You can change the Remote Access Code to any 3^digit number from
1 Press and release .CHANGE] . The Message Window displays C H .
2 Press and release ICODEI. The system announces "First digit."
3Press MP/SCAN] or JWEAT/SCAN] to change the digit.
4When the Message Window displays the desired first digit, press and release WDEJ- The system announces "Second digit."
5Press ]SKIP/SCAN\r lflfP£4r/Sc;i«i to change the digit.
6When the Message Window displays the desired second digit, press and release
[COPIj. The system announces "Thir d digit."
7Press ]SKIP/SCAN\r ]REPEAT/SCAN] to change the digit.
8When the Message Window displays the desired third digit, press and release {CODE'.. The system announces the new Remote Access Code.