Remote Operation

SCO

Playing Messages

1Dial your telephone number from a touch tone phone.

2When the system answers, enter your Remote Access Code. The system announces the number of messages received, then beeps twice.

3After the two beeps, wait 4 seconds, and the system plays back messages

— O R —

Press and release Q] to play all messages

— O R —

Press and release 2 to play only new- messages ( i f there are no new messages, the system announces "N o new messages.")

4 To repeat a message — Press and release \4_ while the message is playing. To repeat part of a message — Hold down gj- To resume playing, release H -

To skip a message — Press and release while the message is playing.

H". To resume playing, release 6 .

To stop message playback — Press and release dl .

To save messages, hang up.

Oeletlng Messages

To delete selected message — Press and release % while the message is playing. To delete all messages — After you have listened to all messages and heard the 2 beeps, press g), [3].

Record Announcement

1Press [2, [*]•

2Speak after the beep, then press (U to stop recording. The system replays your new announcement.

To review your announcement — Press 0 , [7].

Record a Memo

1 Press # and begin speaking after the beep.

2Press fs] when you are finished.

Room Monitor with Intercom

You can call the answering system and listen to any activity in the room.

1Press :9 , iT to listen for 30 seconds.

2I f you wish, you can press [Tj while the monitor is active to speak to some- one in the room (up to 30 seconds).

3Press i a g a i n during intercom operation to return to listening only.

4Press [5j at any time to exit Roo m Monitor with Intercom.

Ending the Remote Access Call

Press i¥j, i9]. The system announces "The machine w i l l now hang up," and disconnects from the line.

Changing Remote Access Code

1 Press m, [9]. The system announces "Enter new code."

2 Enter your new Remote Access Code,

^„ ^ y number between 500 and 999. ^_ 3 I f a valid code is entered, the system announces the new Remote Access Code. I f an invalid code is entered, the system beeps 5 times rapidly, then beeps

twice. Repeat Steps 1 and 2.

Turn System Off

Press m, [S.

Turn System On

When the system is off, it answers after 10 rings and beeps twice.

1Press 0 to turn the system on.

2The system beeps twice and is ready to answer calls and record messages. I f the

-t system beeps 5 times, the memory is full .

Memory FuR

I f the system answers after 10 rings and beeps twice instead of playing your announcement, it might be off or memory might be full .

1Enter Remote Access Code after 2-beep signal.

2Listen to messages, and delete some or all of them.

3Press \0] to make sure your system is on before you hang up.