Installation
Wall-Mounting the Base
Mounting the Base on the Wall
To mount the base on the wall (Figure 5: Mounting the Base on the Wall):
1.Run the base line cord in the wide wire channel as shown, but do not plug it into the base.
2.Run the AC adaptor cord in the narrow wire channel as shown, but do not plug it into the base.
3.Using suitable fasteners, attach the
-To make the base easier to remove later on, consider not tightening the fasteners all the way.
4.Snap the base onto the
-Make sure the mounting ears fit all the way into their slots and the mounting tabs snap into place.
5.Connect the base line cord and AC adaptor cord to the base.
Mounting ear
80683 |
|
- | Line cord |
14 | |
| |
| in wide |
| channel |
AC adaptor cord
in narrow channel
Mounting tab
Wall
Figure 5: Mounting the Base on the Wall
To remove the base from the wall:
-If you did not tighten the fasteners, you can slide the base off the wall before going to the next step.
1.Unplug the line cord and AC adaptor cord from the base.
2.Press the mounting tabs to release the
1
DS1000/2000 Cordless Telephone User Guide | Chapter 1: Installation ◆ 7 |