AT&T EP5632 user manual FCC Part

Page 108

Appendix

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Re-orient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more. If you choose to use a clipping device, please make sure to only use the supplied AT&T belt clip.

104

Image 108

Contents User’s manual Congratulations On your purchase This AT&T productBefore you begin Parts checklist Your new AT&T EP5632/EP5632-2 telephone system includesTable of contents Quick reference guide HandsetTelephone Base Answering system keys and NavKeys in bracketsHandset status icons 1200AM Handset main menu DirectoryTelephone base main menu DirectoryInstallation setup Avoid placing the telephone base too close toTelephone base installation Important InformationInstallation options Desktop to wall mount installationBracket grooves DSL filter For DSL users, see Mounting studs Wall mount to desktop installation DSL filter For DSL users Not included Telephone line cord Battery installation & charging StepBelt clip & optional headset Expanding your telephone system Adding new handsets optional Register HandsetSpare battery optional Introducing Bluetooth Glossary of terms Bluetooth at glance Bluetooth Setup 1200 AMSet up Cellular Set up Headset Set up HeadsetManaging your devices Paired DevicesRename a paired device Delete a paired device Delete all paired devicesView device information Active Devices Replace an active device Remove an active deviceAdd an active device Change PIN of the telephone baseHandset settings Set Time Edit Handset NameShow Handset Name Keypad ToneLanguage LCD Contrast Clear Voice MailDefault Settings restore settings Delete RegistrationRegistration? Handset Ringers Ringer Volume Ringer Melody Select a ringer melodyDelete a ringer melody Record New Ringer Handset Pictures Handset Animations Telephone base Settings 2007/01/01 1200 AMSet Date Keypad Tone LCD Contrast Default Settings Delete HandsetsTelephone base Ringers Ringer Volume Ringer for Home Ringer for CELL1 Ringer for CELL2 Answering System settings Answer On/Off To turn the answering system on or offAnnouncement Recording an announcementNumber of Rings Enter your desired four-digit code by using 5000Remote Code Msg Alert Tone Telephone operations Using a handset Using the telephone baseUsing a Bluetooth headset Make a Home callReceive a Home call Call waiting on the Home lineMake a Cellular call CellularReceive a Cellular call Press Cellular or SpeakerAdjusting the listening volume Using the telephone base Press Volume Silencing the ringersIncoming Home calls Incoming Cellular callsMute HoldReceive a Cellular call while on a Home call Cellular call, CELLULAR, and 1 orReceive a Home call while on a Cellular call Conferencing Home and Cellular calls End Cell call ends the Cellular line callCall waiting while on a conference call Using the telephone base Press Intercom IntercomDirectory Creating a new directory entry Saveerase Creating a new directory entry Using the telephone base Searching for directory entries Edit a directory entry Deleting directory entries Delete one directory entryDelete all directory entries Information about caller ID with call waiting 1200AM Call LogCall Log information Memory MatchReviewing the Call Log Dialing a call log entry Dial optionsUsing the handset Saving call log entries into the DirectoryDeleting call log entries Play recorded messages in the Call Log Clear Missed Calls Redial list Saving redial entries into the Directory Dialing a redial entry Editing a redial entryDeleting redial entries Answering system operations Message announcements Options during playbackTo delete all messages Call Screening on the telephone baseCall intercept Record MemoRemote access Remote Command and ActionAlert tones Handset and telephone base alert tonesTroubleshooting Cannot pair my cell phone to the telephone baseCannot put My headset My telephone Battery Hear other calls Charge light is off Answering Important safety information Especially about cordless telephones Precautions for users of implanted cardiac pacemakers Especially about telephones answering systemsFCC Part 68 and Acta 103 FCC Part Limited warranty 106 Please retain your original sales receipt as proof Purchase Index Cellular calls 59 Conference calls 65 Home calls109 Cellular calls 64 Hold Technical specifications Telephone operating rangeRemote access wallet card 112

Related manuals

Manual 30 pages 51.44 Kb