Binatone 5 manual Installation, Locating the Base unit, Into a modular wall jack

Page 4

2. Installation

1. Locating the Base unit

The Base unit should be placed on a level surface, in a position where:

„the telephone line cable will reach your telephone line socket or extension socket.

„it is not close to a sink, bath or shower, or anywhere else where it might get wet.

„it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, fluorescent lights, etc.

2.Plug the coiled handset cord into the Handset. Plug the other end into the jack on the left side of the Base unit.

3.Place the Handset in the Base unit.

4.Plug the telephone line cord into the PHONE LINE jack at the back of the Base unit. Plug the other end

into a modular wall jack.

Installing Backup batteries

1.Remove the Battery cover and insert 3 X 1.5V AA size alkaline batteries (not included) into the battery compartment paying attention to the polarity marking as shown inside the compartment.

2.Replace the battery cover until it clicks into place.

Warning: Disconnect the telephone from the telephone line before changing the batteries.

5.Lift the Handset and check for Dial tone in the earpiece.

Always use the telephone line cord supplied with your SpeakEasy 5. Other telephone line cords may not work.

Note: The Caller display will not work without batteries installed.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Page Page Page Locating the Base unit InstallationInto a modular wall jack Desk Mount Desk/Wall mount installationWall Mount Desk/Wall mount continue Setting up your phone Setting up continue Default setting is Contrast settingDefault, 300MS, or 600MS Press UP or Down button to select yourTelephone Operation Ringer volume To make a CallTo answer a To end a call Telephone operation continueInserting a Pause in the dialing sequence Storing a NumberMemory Speed dialingOutgoing call record Outgoing call record continue Storing anInto PhonebookTo view Phonebook Record To add a New record Into Phonebook functionPress Phonebook button again Phonebook function continue To delete a Record fromPress Phonebook button to confirm the edited name Wish to editCaller Display operation Caller Display listPress Cancel button Caller Display operation continueViewing the 1 Caller Display list To return a call With the phone on standby mode, press UP or Down buttonPress and hold Cancel button To delete All Caller 1 Display recordsRecord 1 into the Phonebook Memory Storing a Caller DisplayWith Call Caller DisplayWaiting Cleaning and care Electrical safetyOperational notes Troubleshooting Troubleshooting continue PBX useTroubleshooting continue While the unit is under Guarantee Guarantee and serviceAfter the Guarantee has expired Technical details Declaration of conformityContents of this User Guide 0845 345
Top Page Image Contents