Avaya 9103 manual FCC Regulations

Page 5

FCC Regulations

Pertaining to this equipment

Interference Information (Part 15) Some telephone equipment generates and uses radio frequency energy, and if not installed and used properly, may cause interference to radio and television reception.

Your Lucent Technologies product has been tested and found to meet the standards for a Class B computing device, as specified in Subpart J of Part 15 of the FCC Rules. These specifications are designed to provide protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.

If your Lucent Technologies product causes interference to radio or television reception when in use, you might correct the interference with any one or all of these measures:

1Where it can be done safely, reorient the receiving television or radio antenna.

2To the extent possible, relocate the television, radio, or other receiver with respect to the telephone equipment.

3If your telephone product runs on AC power, plug your product into an AC outlet that’s not on the same circuit as one used by your radio or television.

Registration Information (Part 68) The following information is applicable only to equipment connected directly to the telephone network and not to connection of stations behind terminal systems.

In compliance with the FCC Rules, you should be aware of the following:

1Connection of this equipment to the telephone network must be through one of the standard network interface jacks. These jacks may be ordered from the local telephone company or through Lucent Technologies as your authorized agent.

2Registered equipment may not be used with coin telephone lines or party lines.

3Customers connecting equipment to the telephone network will, upon request of the local telephone company, provide the following information:

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 7HOHSKRQH QVWUXFWLRQ0DQXDO Page Ordering Information Copyright 1996 Lucent Technologies All Rights ReservedContents FCC Regulations Page Use Important Safety WarningsService Your 9103 Telephone Lucent Technologies 9103 Telephone, Top and Bottom Views Line jack on top/rear side of telephone Ringer indicator/Message lightData jack on top/rear of telephone On Hook Dial buttonMemory-Dialing buttons Save buttonAuto button Program buttonTone/Pulse switch Battery compartmentRinger volume switch Ringer pitch controlInstalling the Batteries InstallationContents of the 9103 Package Desk/Table Installation Answering and Placing a Call To answer a call Using the FeaturesTo place a call To change from the handset to the speaker during a callTo store a number on any of the three Memory-Dialing buttons Memory-Dialing FeatureTo dial a number stored on a dial pad key To use the Redial button to redial a number you just dialed To store a number on the Save buttonTo call a number stored on the Save button Conference To add a third party to a call Hold To put a call on holdTo return to the held call Failure to Operate and Service Difficulties General Care and MaintenanceCleaning
Top Page Image Contents