Avaya 9103 Battery compartment, Tone/Pulse switch, Ringer volume switch, Ringer pitch control

Page 13

The BOTTOM VIEW includes the following:

15) Battery compartment

You may place two 1.5-Volt AA batteries in this compartment in case of power outage.

16) Tone/Pulse switch

This switch us used to select the dialing mode, either TONE (DTMF) or PULSE (Decadic). The correct mode depends on the telephone network.

17) Ringer volume switch

The settings on this switch affects the ringer volume during an incoming call. There are three available ringer volume positions: Low, Medium, and High.

18) Ringer pitch control

The pitch of the ringing sound can be changed by rotating this control on the bottom of the telephone.

5

Image 13

Contents 7HOHSKRQH QVWUXFWLRQ0DQXDO Page Ordering Information Copyright 1996 Lucent Technologies All Rights ReservedContents FCC Regulations Page Use Important Safety WarningsService Your 9103 Telephone Lucent Technologies 9103 Telephone, Top and Bottom Views Line jack on top/rear side of telephone Ringer indicator/Message lightData jack on top/rear of telephone On Hook Dial buttonMemory-Dialing buttons Save buttonAuto button Program buttonTone/Pulse switch Battery compartmentRinger volume switch Ringer pitch controlContents of the 9103 Package InstallationInstalling the Batteries Desk/Table Installation Answering and Placing a Call To answer a call Using the FeaturesTo place a call To change from the handset to the speaker during a callTo store a number on any of the three Memory-Dialing buttons Memory-Dialing FeatureTo dial a number stored on a dial pad key To call a number stored on the Save button To store a number on the Save buttonTo use the Redial button to redial a number you just dialed To return to the held call Hold To put a call on holdConference To add a third party to a call Cleaning General Care and MaintenanceFailure to Operate and Service Difficulties