Avaya 9103 manual Service

Page 8

telephone is subsequently used. If your telephone does not work properly, refer to the information below which describes how to get service for your telephone.

Service

1Before cleaning, unplug the telephone from the modular wall jack. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. (See General Care and Maintenance later in this manual.)

2Unplug the telephone from the modular wall jack. Be sure to refer servicing to qualified service personnel when these conditions exist:

If liquid has been spilled into the telephone.

If the telephone has been exposed to rain or water.

If the telephone does not operate normally by following the operating instructions, adjust only those controls described in these instructions. Do not attempt to adjust any other controls since doing so may result in damage to the telephone and will require extensive work by a qualified technician to restore the telephone to normal operation.

If the telephone has been dropped or the housing has been damaged.

If you note a distinct change in the performance of the telephone.

WARNING: When this product is located in a separate building from the telephone communications system, a line current protector MUST be installed at the entry/exit points of ALL buildings through which the line passes.

The following are the ONLY acceptable devices for use in this application:

Lucent Technologies 4-type protectors, except the 4C3S-75 “Enhanced” Protector

SAVE THESE INSTRUCTIONS

When you see this warning symbol on the product,

!refer to the instructions booklet packed with the product for more information before proceeding.

Image 8
Contents 7HOHSKRQH QVWUXFWLRQ0DQXDO Page Copyright 1996 Lucent Technologies All Rights Reserved Ordering InformationContents FCC Regulations Page Important Safety Warnings UseService Your 9103 Telephone Lucent Technologies 9103 Telephone, Top and Bottom Views Ringer indicator/Message light Line jack on top/rear side of telephoneData jack on top/rear of telephone On Hook Dial buttonSave button Memory-Dialing buttonsAuto button Program buttonBattery compartment Tone/Pulse switchRinger volume switch Ringer pitch controlInstalling the Batteries InstallationContents of the 9103 Package Desk/Table Installation Using the Features Answering and Placing a Call To answer a callTo place a call To change from the handset to the speaker during a callMemory-Dialing Feature To store a number on any of the three Memory-Dialing buttonsTo dial a number stored on a dial pad key To use the Redial button to redial a number you just dialed To store a number on the Save buttonTo call a number stored on the Save button Conference To add a third party to a call Hold To put a call on holdTo return to the held call Failure to Operate and Service Difficulties General Care and MaintenanceCleaning