Help If you have any problems using your DECTfax Additional Handset, this section will give you the most common, easy-
Problem
The radio link is not set up between the base station and the handset.
The base station does not ring.
The dial tone is busy each time you dial a number.
Your handset is equipped with a rechargeable battery (NiCad).
The capacity of this battery may drop slightly with time.
In that case:
The Handset screen displays:
INIT = F6
Solution
•Check that the handset battery is properly charged.
•Check that the the base station and handset are properly matched.
•Check that the base station power supply pack is not too close to the radio module.
•Check that the base station ringing is not switched off.
•Check that the dialling mode (Voice or Decimal Frequencies) is compatible with your PABX.
•Check that you have inserted pauses after the 0 or 9 in your memorised numbers if your line is connected to a PABX.
•Allow your handset to discharge completely and then put it on charge for at least
5 hours.
•You should perform this operation about every two months in order to increase the life of your battery.
•If the problem persists despite these precautions, you may need to buy replacement batteries from your distributor.
•Match the handset on a base station Chapter: ÔTo register a handsetÕ.
Customer Helpline
If you have any problems with your DECTfax Additional Handset, call the BT Helpline on
0845 603 1066.
28 | 29 |