BT Response Phone, 125 manual To use call screening

Page 22

To use call screening

Your Response 125 can answer an incoming call for you, allowing you to identify the caller and decide whether to take the call.

1Make sure that the volume is set to an audible level. (See ‘To adjust the volume’, page 11)

2Allow the incoming call to be answered by your Response 125 as normal. You will hear the caller begin to leave their message.

3If you decide to take the call, lift the handset and you can speak to the caller. Recording will stop automatically.

If, when you lift the telephone handset, your Response 125 does not stop recording, either replace the handset and lift again, or press the STOP button.

To cancel any

procedure

Pressing the STOP button will cancel any procedure currently in progress.

After pressing the button your Response 125 returns to ‘answer on’ mode.

These functions of the Response 125 will not operate whilst the handset is off the base unit:

•Volume control.

•Checking/recording/ deleting outgoing message.

•Checking and setting day and time.

•Switching answering machine on/off.

•Checking and setting answer delay.

•Recording a memo.

18

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Userfriendly Guide Lift flap Page At a glance Pages 12,13,14, 16,17 Page Contents Introduction For your recordsSetting up P O RTA N TYour Response 125 is now ready for use Electrical storm Using the telephone Whole number is dialled Or Freefone Using the answering machine When you have Press and hold down the Delete button Your Response 125 announces the currently set minute Press the Play button. Your Response 125 announces Messages are played back in the order they were received You hear a beep To use call screening Remote access To skip back to a previous message Page Help Technical information If you own your Response 125 under BT’s guarantee Playback volume IndexWall-mounting 28 mmPage 46 3
Top Page Image Contents