AT&T 2402 user manual G I S T E R T H E H a N D S E T, To select Display BASE-ID

Page 4

2402_map_2ATT 5/7/02 6:32 PM Page 3

R E G I S T E R T H E H A N D S E T

1Make sure to charge the handset battery pack at least 12 hours.

2

At the 2462 corded base, press MENU .

3

Use

or

to select DISPLAY BASE-ID.

4

Press

OK . The base screen will display the 15-digit Base ID code

 

for about 30 seconds, then return to the idle screen. Write down the

 

Base ID code so you can enter it at the handset in STEP 6 below.

5At the cordless handset, use the softkey to select REGISTER.

6Enter the 15-digit Base ID code.

7Use the softkey to select OK. The screen displays PLEASE WAIT!!.

8After about 45 seconds, the screen displays FOUND BASE. If the handset displays BASE BUSY TRY LATER, the base is in use.

For complete operation instructions, refer to the manual that came with your original handset.

3

Image 4
Contents Revised About Handset Registration F O R E Y O U B E G I NAbout Softkeys Install the handset battery pack A R G E T H E B a T T E R YG I S T E R T H E H a N D S E T To select Display BASE-IDBelt Clip InstallationHeadset Battery Life Charge the Handset Battery Pack