AT&T 7406 manual Select Ring and Ringer Volume

Select Ring (and Ringer Volume)
	✔

To select a personalized ring

1Press [ Select ]

●Green light goes steadily

2Press [ Conference Ring ]

●Green light next to [ Select ] winks

●Current ring pattern plays and repeats every 4 seconds

●If you have a display, it shows

[ PERSONAL RING #x ] (x will be a number from 1 to 8)

3Continue to press [ Conference Ring ] to cycle through all 8 ring patterns

4When you hear the desired ring pattern, press [ Select ] again

●Your new ring is set; light next to [ Select ] goes off

Note: If you receive a call, go off-hook, or lose power during selection, the process is interrupted and you must start again.

To adjust ringer volume if necessary (speaker is not active)

1To raise the volume, press the right half of the Volume control button labeled [ ∧ ] ;

to lower the volume, press the left half of the Volume control button labeled [ ∨ ]

●If you have a display, it shows

[ RINGER L > > > > H ] (There are 8 possible volume settings. On the display, 1 arrow is the lowest setting; and 8 arrows is the highest setting)

23