Telephone Memory

This telephone can store 13 telephone numbers, each up to 32 digits. Dial the numbers stored in memory by pressing one or two buttons.

Storing Numbers in Memory 1. Lift the handset.

2. Press and release PROG.

3. Dial the telephone number (up to 32 digits) or press PAUSE/REDIAL to store the last number dialed from this telephone.

4. For one-touch dialing, press and release the memory but- ton where the number is to be stored (M1, M2, or M3). For two-touch dialing, press MEMORY, then press the number button (0-9) where the number is to be stored.

Storing a CID Call Record into Memory

1.Lift the handset.

2.Press P or Qto display the call record to be stored in memory.

3.Press PROG.

4.Go to step 4 above under

Storing Numbers in Memory.

NOTES:

•If you pause for over 10 sec- onds when programming an entry, the procedure will time- out and you will have to begin again.

•If you have difficulty storing numbers in memory, please see

Difficulty storing numbers in memory on page 31.

•Each 3.6 second pause counts as one digit when storing num- bers in telephone memory.

Storing a Pause

in a Memory

Number

Press and release

PAUSE/REDIAL

once to store a 3.6 second pause in the dialing se- quence, twice for a 7.2 second delay,

three times for a 10.8 second delay.