AT&T 205 user manual Handset Installation

Page 14

HANDSET INSTALLATION

1.Plug the handset cord into the jack on the lower side of the telephone base.

2.Plug the other end of the cord into the handset and put the handset on the telephone base.

3.Lift the handset and listen

for a dial tone. If there is no dial tone, see IN CASE OF DIFFICULTY.

NOTES:

•You can make and answer

calls as soon as the	Handset tab
telephone is connected to a	Handset tab
telephone jack.
• If the handset tab on the
telephone base is not
reversed, the handset will
not stay in the cradle when
mounted on a wall. If you
later move this telephone to
a table or desk, be sure to
reverse the handset tab
again.
	Handset cord

11

Image 14

Contents Trimline Page Table of Contents Safety Information Important Product InformationConnection and use with the nationwide telephone network FCC and Acta InformationProduct identifier and REN information Repair instructionsRights of the telephone company Programming/testing of emergency numbersInterference Information Part 15 of FCC Rules Hearing aid compatibilityLimited Warranty What is not Covered by this Limited WARRANTY? Other Limitations Avoid rough treatment Care and MaintenanceLocation Parts Checklist TABLE/DESK Installation Please seeWall Mount Handset Installation Flash OperationHandset Operation RedialTelephone Base Operation Handset VolumeDial Mode Telephone Does Not Ring or Rings Too Softly Case of DifficultyNo Dial Tone Calls Cannot Be Dialed or Are Dialed SlowlyPage