Alpine cda-7873, CDA-7875 Installation, Slide the mounting sleeve into the dashboard, Removal

Installation

Metal plate

Detachable

Front panel

Caution

When you install this unit in your car, do not remove the Detachable Front Panel.

If the Detachable Front Panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

1	Mounting Sleeve
	(Included)

Dashboard

�

CDA-7977/CDA-7876/CDA-7875/CDA-7873

Slide the mounting sleeve into the dashboard.

2

Screw

Hex Nut (M5)

∗∗

Bolt Stud

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-7977/CDA-7876/CDA- 7875/CDA-7873. Connect all other leads of the CDA- 7977/CDA-7876/CDA-7875/CDA-7873 according to details described in the CONNECTlONS section.

3

Lock Pin

Slide the CDA-7977/CDA-7876/CDA-7875/CDA- 7873 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Removal

1Remove the DETACHABLE FRONT PANEL.

2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Metal
Mounting	∗
Strap

CDA-7977/

Ground LeadCDA-7876/

Chassis CDA-7875/

CDA-7873

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

NOTE

CDA-7977/

CDA-7876/

CDA-7875/

CDA-7873

Ground Lead

∗

Face Plate

Screws (M5 × 8) (Included)

For the screw marked **, use an appropriate screw for the chosen mounting location.

Mounting Bracket

NOTE

Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

29-EN