AT&T 135 Connect short line cord to telephone, Reinstall the base, Reverse the handset tab

AT&T 135 Quark pdf 7/22/98 11:26 AM Page 4

INSTALLATION (continued)

2.Connect short line cord to telephone.

Plug the 5-inch line cord into the LINE jack on the bot- tom of the phone.

3.Reinstall the base.

Turn the base so that the larger end is toward the bottom of the telephone. Reinstall the base by inserting the top tabs into the phone slots. Then slide sideways in the direction of the “INSTALL” arrow to lock into the phone.

4.Reverse the handset tab.

To mount the telephone on a wall, you must reverse the handset tab. This tab holds the handset when you hang up. Hold down the switchhook, and slide the tab up and out of its slot (Figure 1). Turn the tab so that the end with the “hook” is up (Figure 2). Then insert the tab back into its slot (Figure 3).

Figure 1 Figure 2 Figure 3

5.Connect the line cord to the modular jack and mount the phone onto the wall jack.

Plug the free end of the line cord into a modular wall jack. Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely (Figure 4).

Figure 4

3