INSTALLATION
To set up the CrystalTone , all you do is connect the telephone line! You can also choose to mount the phone on the wall.
CrystalTone includes the following parts:
✔CrystalTone amplified phone
✔Handset with coiled cord
✔
✔
✔Desktop/wall adapter
CAUTION! Do not plug the CrystalTone into any telephone line other than a standard, analog telephone line. Connection to a digital system may damage the CrystalTone or the telephone system and will void your warranty.
1. SELECTING A LOCATION
The CrystalTone requires a standard (analog) telephone line with either pulse or tone (also called touchtone) dialing. To use the CrystalTone with a digital system, some modifications to the telephone line are required.
Set up the CrystalTone in a place where:
✔There is a phone jack nearby.
✔The surface it is set on, or mounted to, is stable and secure.
✔The area is protected from excessive heat or humidity.
2.REMOVE DESKTOP/WALL ADAPTER
If it is connected, remove the
replaced after setup is complete.)
3. SETTING PULSE OR TONE DIALING
The CrystalTone is preset to use tone dialing because this is used by most telephone lines. If your line uses pulse dialing, move the
switch located on the bottom of the CrystalTone to the “Pulse” setting.
4. SETTING UP THE CRYSTALTONE
For Desktop Use
1.Connect the uncoiled end of the handset cord to the jack on bottom of the CrystalTone . Plug the other end of the cord into the handset.
2.If the desktop/wall adapter is not removed, remove it now (see step 2).
3.Plug the telephone line cord into the telephone line jack on the bottom of the CrystalTone and the other end into the wall phone jack.
4.Replace the desktop/wall adapter so that the larger side is along the top edge of the CrystalTone .
5.Set the Crystal- Tone on a sturdy surface such as a desk, table or counter.
4 ■ INSTALLATION