Mounting on a Wall
1.Flip the handset hook over so that the hook points up and will hold the handset when you hang it up.
2.Connect the uncoiled end of the handset cord to the jack on bottom of the CrystalTone . Plug the other end of the cord into the handset.
3.Plug the
4.Replace the desktop/wall adapter so the larger side is down. This aligns the CrystalTone so that it is flat when mounted on the wall.
5.Plug the telephone cord into the wall jack. Then, line up the
holes in the wall- mount bracket with the mount- ing studs on the wall plate. Hook the bracket on
the studs then pull down.
5.CONNECTING AN EXTERNAL SIGNALER
To use a separate, optional signal light, plug the signaler into an unused extension telephone wall jack.
If you have only one jack that is being
used by the CrystalTone , you can use a
“duplex jack”).
Plug both the CrystalTone and the signaler into the
6. CONNECTING A HEADSET RECEIVER
The CrystalTone provides an audio jack for direct audio connections with some assistive listening technology. A headset with a 3.5 mm jack may also be used. The headset may be either mono or stereo. The jack, which is labeled with the headset symbol ( 
), is located on the right side of the CrystalTone .
CALLING & ANSWERING
The CrystalTone works just like any telephone.
PLACING A CALL
1.Lift the Handset.
2.Listen for the dial tone.
3.Dial the number of the person you are calling. When the person answers the phone, begin your conversation.
4.During a conversation, you may want to adjust the volume and quality of the sound coming through the handset (see “Adjusting the Sound ” on the next page).
ANSWERING A CALL
1.When you receive a call, the CrystalTone rings and the Ring Indicator flashes slowly along with the rings.
NOTE: If the ring volume is not loud enough to alert you to a call, you can increase the ring volume (see “Adjusting the Sound ” on the next page).
2.Pick up the handset to answer the call and begin your conversation.
INSTALLATION ■ 5