Aastra Telecom CM-16 manual Battery Charging, Belt Clip, Using a Headset with your Telephone

Page 7

CM16.book Page 6 Friday, June 18, 2004 3:22 PM

Battery Charging

The handset is powered by a nickel metal hydride battery pack. To install and charge the battery:

1.Slide the cover off of the battery compartment.

2.Place the battery pack in the compartment with the connector wires pointing towards the bottom of the handset.

3.Connect the battery terminal wire to the charging pins located in the compartment

4.Slide the cover of the battery compartment back onto the handset

5.Place the handset, face up, in the charging cradle. The handset should easily slide into the charging cradle. If it does not, check the battery compartment cover to ensure it is in the proper position.

To confirm that the battery is charging, check the battery icon symbol on the handset display to see if the lines inside the icon are flashing left to right.

Note: The battery must be charged for a minimum of six hours prior to initial usage of the phone.

Belt Clip

To install the belt clip, snap one arm of the clip into the slot on the side of

the handset and then slide the other arm into the slot on the other side of the handset until it snaps into place.

Using a Headset with your Telephone

The CM-16 accepts headsets through the jack on the bottom of the handset. Contact your telephone equipment retailer or distributor to purchase a compatible headset. Customers should read and observe all safety recommendations contained in headset operating guides when using any headset.

BATTERY STATUS ICONS

The display provides “at a glance” information on the handset battery

The bars indicate the battery charge level — 4 for full, needs recharging when only 1 bar appears.

The bars will flash when the battery is being recharged on the charger stand.

Note: The handset is designed to recharge the batteries automatically, when required and placed on the charger stand. The battery icon will not flash and the handset does not charge every time it is placed on the stand. If a defective battery is replaced, then the battery Icon is not identified until the new battery is charged for

at least 2 minutes.

Model CM-16 User Guide 6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents CM16.book Page i Friday, June 18, 2004 322 PM Table of Contents Handset and Base Station Safety InformationBatteries Regulatory Information Base Station InstallationFigure a Charging CradleBelt Clip Battery ChargingUsing a Headset with your Telephone Battery Status IconsCM-16 Handset KEY Functions CM16.book Page 8 Friday, June 18, 2004 322 PM Screen Icons Screen DisplayScreen Prompts Redial Making and Answering CallsMute KEY Volume ControlTo delete an entry in the Redial list Hold FunctionStatus Light To adjust the receiver volumeTo adjust the ringer volume Features ListLanguage OptionsTo delete a single key label To delete all feature label textKey label To edit key label textRing Tone Call TimerCustom Name Vibrate Handset PairingKey Lock Silent Alert BacklightAdding a name and number to the Directory DirectoryEntering Letters and Characters Dialing from the Directory Finding entries in the DirectoryChanging entries in the Directory Deleting all entries in the Directory Deleting an entry in the DirectoryExclusions Limited WarrantyAfter Warranty Service Warranty Repair ServicesCM16.book Page 23 Friday, June 18, 2004 322 PM CM-16 Handset KEY Functions IndexStatus Light
Top Page Image Contents