Linear AE-100 Modify AN, Existing Tenant, Directory Entry, Not Available, Delete AN, Entries

ALTERNATE PROGRAMMING METHOD

FUNCTION CODE	LOCAL PROGRAMMING		TELEPHONE PROGRAMMING
02	Step 1 Enter Function Code 02, then press #.
MODIFY AN		MODIFY DIR:
EXISTING TENANT
	Step 2 Enter the new 2 or 3 digit Directory Code.
DIRECTORY ENTRY
Choose a tenant’s Directory		ENTER THE NAME:
Code to modify (you must know
the tenant’s Directory Code to	Then the tenant’s current Name is displayed:
modify).
		(CURRENT NAME)
	Step 3 To keep the Name press # and skip to Step 5.
	Step 4 To change the Name press ✱ then enter a new
	Name (up to 16 characters), press # after each
	character, then # again after the last character:
		Phone number	NOT AVAILABLE
		(current PH#)
	Step 5 To keep the Telephone Number
	press # and skip to Step 7.
	Step 6 To change the Telephone Number press ✱ then
	enter a new Telephone Number (up to 14 digits),
	press # after each number, then # again after the
	last number. Press and hold down the 1, 2, 3, or 4
	key for about two seconds to enter 1-4 two-second
	pauses. Note: Each pause entered counts as one
	of the 14 digits allowed in the telephone number.
		ACCESS CODE:
		(current CODE)
	Step 7 To keep the Access Code press #.
	Step 8 To change the Access Code, enter a new
	4-digit Access Code, then press #.
03	Step 1 Enter Function Code 03, then press #.		Step 1 Enter Function Code 03 and
			press #, one short beep sounds.
DELETE AN		DELETE DIR:
			Step 2 Enter the Directory Code (2 or 3 digits)
EXISTING TENANT
	Step 2 Enter the 2 or 3 digit Directory		to delete and press #, two short beeps
DIRECTORY ENTRY
			sound. (If you hear one long beep
Deletes a single existing Directory	Code to delete, then press #:
			followed by two short beeps, the Directory
Entry. This command frees up		(DIR CODE)
			Code did not exist, return to Step 1.)
memory occupied by an unused		IS DELETEd !
Directory Entry.
	If the Directory Code does not exist, the
	display will show an error, return to Step #1.
		ERROR ON DELETE
04	Step 1 Enter Function Code 04, then press #.
CLEAR ALL TENANT		DELETE ALL? 13
DIRECTORY
	Step 2 Enter the number displayed, then press #:
ENTRIES
Deletes all existing Directory		ARE YOU SURe? 5	NOT AVAILABLE
Entries. This command will
erase all Directory Codes,
	Step 3 Enter 5 for verifi cation, then press #
Names, Telephone Numbers and
directory-linked Access Codes.	(or press ✱ to cancel).

CAUTION: This utility command will erase ALL the Directory Entries in the unit.

16