Kompernass KH5001 manual Wall Mounting, Connecting the receiver

Page 8

e-bench KH 5001

2^ Calling Phone Book / Saving settings 2& TAE connecting cord

2* Battery compartment

2( Adjusting Ring tone volume

6. Connecting

If you have carefully read through the safety instructions, you may now connect the phone:

a) Connecting the receiver

Insert the spiral cord connectors into the narrow sockets...

on the left side of the telephone unit...

and below the receiver.

b) Connecting to the PSTN line

Insert one end of the plain phone cord into the large socket at the back of the Telephone and the other end...

into the socket marked "F" on the TAE socket (connection to the PSTN line). In the case of sockets with 3 in- lets sockets this is the middle socket.

c) Inserting the batteries

2* Open the battery compartment cover on the rear side. Insert three UM4/AAA type batteries of 1.5V. Make sure that the "+" sign on the batteries matches with the alignment seen inside the battery compartment.

d) Changing the batteries

Change the batteries as soon as pos- sible if the display window shows the alert "BATTERY LOW".

Used batteries should not be dis- posed of in the household waste. Return these to your retailer or to an appropriate collection site for disposal.

7. Wall Mounting

For mounting the appliance on a wall select a position which is both level and at which there are no electrical cables or pipelines for water, gas or drainage installed.

Remove the phone fuse

below the

 

phone retaining fork, turn it through

 

180° and then push it back in until it

 

firmly engages.

 

Place the spacer piece

in the groove

on the left side of the underside of the telephone and press it down until it engages in the groove on the right side.

Lay the connecting cable in the cable

channel of the spacing piece .

Hang the telephone by the wall

bracket , using 2 screws fixed

in the wall and spaced at a distance of 118 mm.

8. Initial settings

After the first insertion of batteries the following functions are called up with the receiver on the hook:

a)Selecting the display language Selecting the language of your choice for messages in the display window:



- 6 -

Image 8
Contents Kompernass Gmbh · Burgstrasse 21 · D-44867 Bochum  Analogue comfort telephone KH5001 Page # 2$ 2% 118mmWall Mounting Initial settings Network features MemoryOperating elements Connecting the receiver Wall MountingChanging the display language To call the programming modeEntries for the Incoming call list Adjusting the display contrast Setting the dial tone code Receiving phone calls Place the receiver on the hook orTo make outgoing calls Displayed number Copying Phone Book entry from the list Mailbox message Sleep functionCall Disabling the Single button emergency callDo not dispose of the device in normal domestic waste To clean the appliance, only use a soft dry clothTo delete a single entry in the display Battery disposal Dial in Pulse