tPress the 
button, till the desired language appears in the
display window.
2^ Press the 
button, to save the selected setting.
If this function is not presented automa- tically – or, if you wish to once again call this function at a later point of time:
This can be done through the program- ming mode as described under Section 8.
b) Allocating the memory capacity
This function, as described here, will appear only when starting the opera- tions in a new phone – it cannot be recalled later! However, you can call this function only by removing the batteries for more than 10 minutes. In such case, all entries in the Phone Book and other settings are lost.
Phone Book and Incoming call list share a common memory area. The following memory allocation is preset at factory:
–32 entries for the Phone Book:
–65 entries for the Incoming call list
Using this function, you can change the memory allocation between Phone Book and Incoming call list:
Phone book: Max. 112 entries
Incoming call list: Max 91 entries
tFor this, press the 
button to change the number of entries for
the Phone Book. If you...
–decrease the preset number, the Incoming call list will be increased by a corresponding number,
–increase the preset number, the Incoming call list will be decreased by a corresponding number.
Setting the Phone Book size alone is enough to achieve this. As this concerns the memory allocation, any changes made for one of the two numbers will affect the other number.
2^ Press the 
button, to save the settings.
9. Basic settings
The functions described here are only accessible in the programming mode.
To call the programming mode,...
2@ hold the 
button for at least 3 seconds while the receiver is on hook. Now the display starts blinking with the selected language.
2@ Each time you press the 
you can scroll through all setting options.
To terminate the programming mode, ...
2^ press the 
button twice, or...
•refrain from operating any button for more than 10 seconds. The phone will return to the normal operating state.
a) Changing the display language
If you have called the programming mode, first the set language will start blinking in the display window. You can change this as described under 7.a).
- 7 - |