Aastra Telecom 7106A System Dependent Phone Setting, Save MWM, Dial from a MWM, Press # 0 1 # X #

System Dependent Phone Setting

Message Waiting Memory (MWM)

There is a message waiting memory in the telephone where the number to the voicemail box shall be stored.

Save MWM

1.Place the handset on the phone and press

2.Press and enter the number to be saved

3.Press key again to complete saving

Dial from a MWM

1.Pick up the handset or press ‘Speaker/Handset’

2.Press the

Message Waiting LED

When there is a message, the message waiting LED will be lighted ON or flashing in blue.

The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode (HV / + / -). Please check which MW type the PBX system supports. Select “OFF” on the MW switch to deactivate the message waiting function.

If the LED is steady active, change the message waiting switch position.

Set Flash time

Some systems require a different flash time for the flash key. To change the flash time, proceed as follows:

1.Press # 0 1 # X #

where X is the flash time value between 1 and 9. See table below

Parameters	Programming key sequence	Lock	Valid	Default
		Protected	Settings
Set flash	[save]+[#]+[0]+ [1]+[#]+[X]+[#]	Yes	1: 100ms	100ms
time			2: 200ms
			3: 300ms
			4: 400ms
			6: 600ms
			9: 900ms

27