Valcom V-1101A specifications Troubleshooting Chart

			TROUBLESHOOTING CHART
Symptom			Solution
1. No output at speakers.	1.	Check for audio on the Red/Brown pair of the V-1101A while paging.
		(a)	If audio is present: Verify proper audio and power wiring to speakers. Try
			connecting a speaker in the equipment room: Connect the Tip and Ring leads
			directly to the Red/Brown pair of the V-1101A and connect the –24 Vdc and
			ground leads to the power supply. Test again.
		(b)	If no audio: Refer to Wiring Instructions and complete the power test (step
			7). Correct any problems and test again. If there is still no audio, then return
			to the installation Figure used and verify ALL connections. Use a meter to
			verify the connections from the punchdown block to the amphenol. If there is
			still no audio and you used Figure 5 Intercom Access, connect a bell or
			buzzer to the V-1101A H and SIG leads. Dial the page access number. If the
			bell or buzzer does not ring, then you are either not getting a page control
			from the intercom, or you have connected the wrong half of the signal pair to
			the V-1101A SIG lead.
2. Music will not cut off	2.	Complete all steps above for “no output at speakers”.
during a page.

T

R

BFT

BFR

AB

AG

H

SIG

DIR

BB

Preamplifier

and

Voice Limiting Ckt

Battery Feed

and

A Relay

Control Circuit

and

CT Relay

Regulator

PG

OUT

MT

	MR
A1	A1
	A1
A2	A2
	A2
CT2	CT
	CT

BG

V-1101A SIMPLIFIED SCHEMATIC

11 947101