Black Box FX810AE, FX801A, FX802A, FX800AE manual Campus Pager system code button

Page 19

CAMPUS PAGER

2.Turn the Campus Pager over and locate the system code button, which is inside the hole labeled SYSTEM CODE. Insert a pointed object such as a straightened paper clip and press the button (see Figure 5-5). The TRANSMIT display will show the previous system code for about one second, then shows ___.

Figure 5-1. The Campus Pager system code button.

3.Enter a three-digit system code. After about one second, the display shows

___, and the system code is stored.

4.If you enter a wrong code, reset it by pressing A/C, CANCEL, or the system code button. Then repeat Steps 2 and 3 to store the system code again.

NOTE

If your application requires more than 100 system pagers, you can use multiple Campus Pager systems. If using more than one Campus Pager, each system should have a unique system code.

21

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Campus Pager Industry Canada FCC StatementCampus Pager NOM Statement Trademarks Contents Specifications Beware of Electric Shock Important NotesCampus Pager IntroductionCampus Pager Tone Pager FX801A Vibrating/Tone Pager FX802A Positioning the Campus Pager InstallationConnecting the antenna to the Campus Pager Connecting the Campus Pager to the mounted screws Connecting Power to the Campus Pager Positioning the Antenna Ground WireInstalling/Replacing Pager Batteries Installing batteries in the pager Overview Using the Campus PagerStoring the System Code Campus Pager system code button Storing the Pager Code Pager ON/OFF SwitchTransmitting a Message Code to a Single Pager Transmitting a Message Code to All System Pagers Receiving a Message Code with the Vibrating/Tone Pager Receiving a Message Code with the Tone PagerReviewing Stored Message Codes Service Information Copyright 1996. Black Box Corporation. All rights reserved
Top Page Image Contents