BASIC OPERATION | BASIC OPERATION |
Making Calls
You can make calls directly from the handset whether you are at the base or away from it. You cannot make calls on the speakerphone in the base but you can answer calls from the base.
From the handset
Pick up the handset and press a LlNE key. When you hear a dial tone, dial the number. The LlNE indicator for the line you are using will turn on.
Disconnecting
To end a call, either place the handset back in the base, or press OFF on the handset.
OFF Mode (STANDBY)
When the unit is OFF the display will be clear except for earpiece volume indicator.
If the screen is completely blank it meansthat the battery is not connected or has insufficient charge to operate the handset. Place the unit in the base to recharge the battery. The base
The volume controls for the handset are located on the side of the unit. Press the A (up) or V (down) keys to increase or decrease the volume. Holding either key down will continuously change the volume setting. The ear piece volume level indicator will change accordingly.
VOLUME
CONTROL
KEYS
TO ANSWER A CALL FROM THE BASE PRESS LlNE 1 OR LlNE 2 FOR THE INCOMING CALL
TO END A CALL FROM THE BASE PRESS OFF
TO MAKE A CALL
PRESSA LlNE KEY,
EITHER LlNE 1OR LlNE 2
PRESS OFF IF YOU
MAKEA MISTAKE
WHEN DIALING. OR
TO HANG UP.
NOTE: There are two different ways to dial out a number:
1.Press the LlNE key and wait for a dial tone. Then dial out the number you want.
2.Enter the number onto the display first, then press the LlNE key. This will dial out the number that is displayed on the LCD after 2 seconds. (See Advanced Dialing on page 24).
If you make a mistake when dialing, press OFF to hang up, then press the LlNE key and wait 2 seconds to get a dial tone again.
charge indicator will stop flashing when the handset battery has received the minimum charge necessary to operate.
Volume Controls
Both the base unit and the handset have digital volume controls. The volume controls for the speakerphone are located on the front face of the base unit. Press the volume up side to increase the speaker volume and the volume down side to decrease the volume. Holding either side down will continuouslychange the volume setting at the rate of 4 steps per second on the base and 2 steps per second on the handset.
. .
Using the Speakerphone
You cannot make calls from the speakerphone. However, you can answer calls from the speakerphone by pressing the LlNE key for the incoming call.
It does not matter whether or not the handset is in the base - you can use the speakerphone in either case.
To end a call on the speakerphone, press OFF.
To Put A Call On Hold
While using the speakerphone or the handset, you can put a call on hold by pressing HOLD. The hold indicator on the base unit will flash to show that a call is on hold.
On the handset, the LlNE indicatorwill flash quickly to show that the line is on hold.
To return to the call, Dress the LlNE key on the handset o; the base.
VOLUME UPIDOWN CONTROL