FCC and IC Regulations | TECHNICAL SPECIFICATIONS |
I
i
I
1
I
I
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the
local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single line individual service may be extended by means of certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations
Repairs to certified equipment should be made by an authorized Canadian maintenancefacility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Caution: User should not attempt to make such connections
The Load Number (LN) assigned to this device denotes the percentage of the total load to be connected to a telephone loop which is used by the device to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the load numbers of all the devices does not exceed 100.
The Load Number of the unit is 7.
Your VT2900is designedto operate at the maximum power allowed by the FCC and IC. This means your handset and base unit can communicate only over a certain distance - which will depend on the location of the base unit and handset, weather, and the construction and layout of your home or office.
If you move the handset out of range during a phone conversation, you will give an 'Outof Range'tone to tell you that the handset will not be able to receive or place calls. You may terminate the 'Outof Range' toneby pressing the OFF key on the handset.
FREQUENCY CONTROL
Crystal Controlled Dual PLL
Synthesizer
TRANSMIT FREQUENCY
Handset: 925.05 MHz to 927.75 MHz (All ten channels within this range)
Base: 902.3 MHz to 905.0 MHz (All ten channels within this range)
RECEIVE FREQUENCY
Handset: 902.3 MHz to 905.0 MHz (All ten channels within this range)
Base: | 925.05 MHz to 927.75 MHz |
| (All ten channels within this |
| range) |
SIZE
Handset: 20.2cm x 6.2cm x 4.5cm ( L x W x T ) maximum ( anntenna excluded )
Base: | 21.5cm x 19.6cm x 6.8cm |
| ( L x W x T ) maximum |
| ( anntenna excluded ) |
WEIGHT
Handset: 345 gams
Base: 1050 gams
POWER REQUIREMENTS
Handset:
capacity.
Base: 12VDC Q 500mA
MEMORY
Speed Dial: 20 locations, 16 digits per location.
ISPECIFICATIONSARETYPICAL AND I MAY CHANGE WITHOUT NOTICE.