TeleTalker Model TEL Bare Wall Installation

TeleTalker ® Model TEL 040

Installation Guide & User Manual

Bare Wall Installation

Even if you don’t have a studded wall phone plate, you can still mount the TeleTalker on any wall surface within six feet of a standard modular jack and AC outlet. To mount the phone farther from the jack you’ll need a longer line cord or a telephone extension cord. In either case, place the AC power pack in a location which will not be subject to distur- bance.

Step 1: Measure and mark the wall for mounting screws. Mark two points 3-14⁄ inches apart for upper and lower mounting screws. The lower mark should be 48–52 inches from the floor. Use a level to make sure the marks are aligned vertically.

Step 2: Install the mounting screws (not included).

Use wood screws for stud mounting, anchor screws for hollow wall mounting. Drive the screws almost completely in, leaving a 18⁄ inch space between the wall surface and the bottom of the screw head (about the thickness of two stacked pennies).

Step 3: Reverse the handset hanger to prevent the handset from falling.

Step 4: Mount the TeleTalker.

Hang the telephone on the mounting screws and push down gently until it snaps into place

Step 5: Connect the line cord to the jack on the top of the phone. Plug the other end of the line cord into a modular wall jack.

Make sure it snaps firmly into place.

Step 6: Connect the AC power pack to a wall AC outlet.

Step 7: Check for the dial tone.

If you can’t hear a dial tone, see In Case Of Difficulty, page 12.

Note: To disconnect the telephone, squeeze the clip on the modular plug and pull it out of the jack.

Williams Sound ®

Helping People Hear