TOA Electronics EX-16 manual Clipping Tool C YC-105

Page 18

Clipping Tool C (YC-105)

Note:

Connect the individual cables in

order, starting with the top ter-

minal.

When using the clipping tool, be sure that the cutting edge is on the side of the wire to be cut off.

Push down

Cutting edge

Clip Terminal

Clip Terminal (Side View)

16

Image 18

Contents TOA EX-16 Intercom System Features Specifications Further Details System Block Diagram Features ExchangeSpecifications Exchange SpecificationsFurther Details EX-16 Dimensions in mm Paging Receiving Switch Transmitting Circuit Control signal System Block Diagram Stations Wall Mounting Panel YC-100 AccessoriesStation Specifications Talk-Back Unit TKU-11Power Source Precautions for Installation ExchangeStations Cable Installation Core Diameter Versus Transmission DistanceDistance as Functions of Core Diameter Wiring General InformationSpacing Piping ExampleConnection between the station and the exchange Clipping Tool C YC-105 Page AC/DC Power Supply Connection Connection of the Input/Output TerminalRemote Control Output BGM InputAll-Call Paging Output Wiring Diagram Connection of the Talk-Back Unit Speaker Volume Adjustment Connection of the Speaker StationConnection with the Exchange 10.4 On/Off Control of BGMHow to Connect the Jumper Wire Jumper for Speaker Station Selection Jumper for BGM On/OffInspect Before Turning Power On Function SelectionTesting Adjusting Method PrecedurePage Trouble Shooting Guide Relationship Between Ambient Noise and Conversation ModeFault in Exchange Fault in Specific Station Only SymptomFault in Cable Line and R-Line are shorted or mixed up KOBE, Japan