TOA Electronics EX-16 manual Trouble Shooting Guide

Page 31

4.3.3Relationship Between Ambient Noise and Conversation Mode

The EX-16 system is provided with voice switches for the press-to-talk function which is required when the ambient noise level is high. Below is a guide for using the press-to-talk function.

(Up to 60 phons)

(Hands free)

(Up to 60 phons)

(A)

(B)

(Hands free)

 

 

(Up to 60 phons)

(Hands free)

(Above 60 phons)

(A)

(B)

(Press-to-talk)

 

 

5. Trouble Shooting Guide

Repairing of the EX-16 system is basically done by replacing defective units with good ones. The system's faults in an installation can be divided into the following categories.

1.Faults in an exchange

2.Faults in a station

3.Faults in cable

To make system repairing easier, find which category is involved, then refer to the chart below for assistance in fault-finding.

All stations do not operate. Same symptom in every station.

Fault in specific station only.

Fault in an exchange.

*Power supply

*Plug-in unit (Common control)

Cable fault.

Fault in a station.

*Mis-wiring such a short, broken wire, etc.

*Misconnection in station jack.

*Key board switch fault.

*Board assembling fault.

*Speaker, microphone fault.

*Microswitch, connecting cable fault.

29

Image 31
Contents TOA EX-16 Intercom System Features Specifications Further Details System Block Diagram Exchange FeaturesExchange Specifications SpecificationsFurther Details EX-16 Dimensions in mm Paging Receiving Switch Transmitting Circuit Control signal System Block Diagram Stations Talk-Back Unit TKU-11 AccessoriesStation Specifications Wall Mounting Panel YC-100Power Source Exchange Precautions for InstallationStations Core Diameter Versus Transmission Distance Cable InstallationDistance as Functions of Core Diameter General Information WiringSpacing Example PipingConnection between the station and the exchange Clipping Tool C YC-105 Page Connection of the Input/Output Terminal AC/DC Power Supply ConnectionBGM Input Remote Control OutputAll-Call Paging Output Wiring Diagram Connection of the Talk-Back Unit Connection of the Speaker Station Speaker Volume Adjustment10.4 On/Off Control of BGM Connection with the ExchangeJumper for Speaker Station Selection Jumper for BGM On/Off How to Connect the Jumper WireFunction Selection Inspect Before Turning Power On Testing Precedure Adjusting MethodPage Relationship Between Ambient Noise and Conversation Mode Trouble Shooting GuideFault in Exchange Symptom Fault in Specific Station OnlyFault in Cable Line and R-Line are shorted or mixed up KOBE, Japan