the number keypad to enter 2 digits for the hour and 2 digits for the minutes, e.g., 0530 for 5:30).
The Global Setup menu
The settings on this menu affect all handsets and the base. Before changing these settings, make sure the phone is in standby and all handsets are within range of the base. (Only one handset at a time can change these settings.)
Set Line Mode | Do not change this setting unless instructed to by | |
customer service. | ||
| ||
| This feature adds “0” or “00” at the beginning of | |
Insert 0 | the number received from Caller ID. The default | |
setting for New Zealand is ON. The default setting | ||
| ||
| for Australia is OFF. | |
VMWI Reset | Reset the message waiting indicator if it gets out of | |
sync with your voice mail service (see page 25). | ||
|
How to enter text on your phone
Use the
xx The phone defaults to a capital letter for the first letter and any letter after a space; otherwise, it uses small letters.
xx To switch to all capital letters, press *. The phone defaults to all capital letters first (e. g. ABCabc2) until you enter a blank space or press * again. (Any time you want to change case, just press *.)
xx If two letters in a row use the same number key, enter the first letter and wait a few seconds (or press Right); the cursor will move to the next space. Enter the next letter.
Press # to enter a blank space.
To change a letter, move the cursor to that letter and press Clear to erase the letter; enter the new one.
To erase the entire entry, press and hold Clear.
Press 0 to cycle through all available symbols and punctuation.