Philips SE765 Declaration of conformity, Power requirements, To avoid damage or malfunction

Page 5

1Important safety instructions

Power requirements

This product requires an electrical supply of 100-240 volts AC. In case of power failure, the communication can be lost.

The voltage on the network is classified as TNV-3 (Telecommunication Network

Voltages), as defined in the standard EN

60950.

Warning

•• The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible.

To avoid damage or malfunction

Caution

•• Use only the power supply listed in the user instructions.

•• Use only the batteries listed in the user instructions.

•• Do not allow the charging contacts or the battery to come into contact with metal objects.

•• Do not open the handset, base station or charger as you could be exposed to high voltages.

•• Do not allow the charger to come into contact with liquids.

•• Risk of explosion if battery is replaced by an incorrect type.

•• Dispose of used batteries according to the instructions.

•• Always use the cables provided with the product.

•• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.

•• Handsfree activation could suddenly increase the volume in the earpiece to a very high level: make sure the handset is not too close to your ear.

•• This equipment is not designed to make emergency calls when the power fails. An alternative has to be made available to allow emergency calls.

•• Do not expose the phone to excessive heat caused by heating equipment or direct sunlight.

•• Do not drop your phone or allow objects to fall on your phone.

•• Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the set.

•• Do not use the product in places where there are explosive hazards.

•• Do not let small metal objects come into contact with the product. This can deteriorate audio quality and damage the product.

•• Active mobile phones in the vicinity may cause interference.

•• Metallic objects may be retained if placed near or on the handset receiver.

About operating and storage temperatures

Operate in a place where temperature is always between 0°C to +35°C (32°F to 95°F).

Store in a place where temperature is always between -20°C and +45°C (-4° F to 113° F).

Battery life may be shortened in low temperature conditions.

Declaration of conformity

Hereby Philips Consumer Lifestyle, P&A, declares that the SE765 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.You can find the Declaration of Conformity on www.p4c. philips.com.

This product has been designed, tested and manufactured according the European R&TTE directive 1999/5/EC. Following this directive, this product can be brought into service in the following countries:

En glish

EN 5

Image 5
Contents Register your product and get support at SE765 EC Declaration of Conformity Contents Alarm clock Auto clock Keypad lock Locate the handset Call forward Call return Call back service ID withheldTurn on/off the answering machine StationDeclaration of conformity Power requirementsVoltages, as defined in the standard EN 60950 To avoid damage or malfunctionDisposal of your old product and batteries Compliance with EMFEn g l is h Congratulations on your purchase and welcome to Philips What is in the boxYour SE765 Select the function Overview of the phoneEarpiece Main menu icons Overview of the base stationDisplay icons Connect the base station Get startedWall mount the base station Set the country Install the handsetCheck the battery level Check the signal strength What is standby mode?Switch your handset On/Off Set the date and timeMake a call CallsEnd a call Adjust the earpiece volumeAnswer a call Mute the microphoneMake a conference call with the external callers Answer a second callToggle between two calls Transfer a call Make a call to another handsetMake a conference call While you are on the phoneDuring the conference call During an external callSp 1 @ # = & € £ $ ¥ ¤ Enter text and number‘ ! ¡ ? ¿ * + % Phonebook Set the melody Add a recordDelete a record Delete all recordsCall log Write and send a new message Text messagesInbox »» SMS Sent ! is displayed.TheForward an inbox message when viewing the message Reply to an inbox message when viewing the messageDelete an inbox message when viewing the message Delete all inbox messages when viewing the messageDraft box Default message centre Message settingsMessages reception Activate/deactivate messages receptionView the redial records Redial listRedial a call Delete all redial recordsPersonalize the sounds Personalize the phone displaySet the theme colour Set the wallpaperSet the contrast level Set the backlight timeDial mode Call featuresAuto hang up Auto conferenceFirst ring Auto prefixSet the recall duration Set auto prefix»» ECO is displayed instead of in standby mode ECO modeCall forward Network servicesActivate call forward Deactivate call forwardID withheld Call back serviceCall return Auto clock Extra featuresAlarm clock Locate the handset Keypad lockLock the keypad Unlock the keypadUnregister the handsets Register the handsetsAuto registration Manual registration»» The welcome screen displays Restore default settingsTurn on/off the answering machine Set the answer modeSet the answering machine Language Through the handsetIncoming messages Outgoing messagesRecord an outgoing message Listen to the current outgoing messageFrom the base Listen to the incoming messagesFrom the handset Delete an incoming message From the baseRemote access Set the ring delayActivate/deactivate the remote access Access the answering machine remotelySet the sound quality of the message Remote access commandsAnswering machine default settings Default settingsTechnical data Handset does not ring Frequently asked questionsRichtlijn 1999/5/EG 1999/5/ECDirective 1999/5/CE Som framgår av direktiv 1999/5/EG0168